![]() ![]() Configure Connectrix MDS Series switches, making sure that the switches to be monitored by using CloudIQ have:.Increase the number of management sessions from 3 (default) to 10 by using the following command:mgmtapp –config -maxrestsession 10. ![]() For example: switch:admin> mgmtapp -show REST Interface State: Enabled REST Session Count: 3 REST Throttling Configurations: Sample Requests : 30 Sample Time (in sec) : 30 Idle Time (in sec) : 3 KeepAlive : Enabled KeepAliveTimout : 15secIf the REST Interface State is not Enabled, run the mgmtapp –enable REST command to enable it. REST API enabled on them.On each switch that the CloudIQ Collector will be accessing, run the mgmtapp -show command to validate that the REST API has been enabled.Refer to the Brocade Fabric OS Administration Guide for upgrade instructions. Configure B-Series switches, making sure that the switches to be monitored by using CloudIQ have:.Once this data has been collected, it is transferred back to CloudIQ for processing by using Secure Remote Services.įor Connectrix data to be shown within CloudIQ, the following steps must be performed: This data collection process occurs every 5 minutes and is performed by the CloudIQ Collector. CloudIQ collects data related to system health, configuration, capacity and performance from Connectrix products that are being monitored. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |